Icom IC-207H - Page 23

:
H Tuning step selection “set Mooe
uning steps are the minimum frequency change increments
yhen you rotate the tuning dial or push the [A] or [¥V]
witches on the microphone. The following tuning steps are
pie
vailable:
ef)
5kHz *10kHz = 12.5kHz = ° 15 kHz
20kHz °©25kHz ¢ 30 kHz ¢ 50 kHz
, NOTE: For convenience, select a tuning step that
Z,
y matches the frequency intervals of repeaters in your area.
) Push [BAND] to select the desired band, if necessary.
) Push [V/MHz] to select VFO mode if another mode has
been selected.
) Push [SET] one or more times until “tS” appears as shown
below.
’ ¢ Pushing [MONI] reverses the order of selection.
_ ¢ Cancel the DTIMF memory function in advance. (p. 48)
) Rotate the tuning dial to select the tuning step.
) Push [V/MHz] to exit set mode.
TE Sar ee Fill
HE Ie a
5 kHz tuning step 25 kHz tuning step
:
|
SETTING A FREQUENCY 3
Gi) Push [BAND] to select the operating band, if
necessary.
Push [VFO] to select VFO mode.
Push [SET] one or more times until “tS” ap-
pears as shown previously.
¢ Push [ENT] to reverse the order of selection.
e Cancel the DTMF memory function in advance.
(p. 48)
[4] Push [A] or [¥] to select the tuning step.
[5] Push [CLR] to exit set mode.
ENGLISH
18