Icom IC-207H - Page 22

3 SETTING A FREQUENCY
@ Using the tuning dial
@ Push [BAND] to select the desired band, if necessary.
@ Rotate the tuning dial to set the frequency.
elf VFO mode is not selected, push the [V/MHz] to select VFO
mode.
e Frequency changes according to the selected tuning steps.
(p. 18)
@ For the 1 MHz frequency setting, rotate the tuning dial after
pushing [V/MHz].
¢ Pushing [V/MHz] for 1 sec. starts a scan function. If this happens,
push [V/MHz] again to stop the scan.
The display shows that the 1 MHz
tuning step is selected for the
VHF band.
@ Using [A]/[¥V] switches
Push [A] or [¥V] to set the selected band’s fi
jv quency.
¢ lf VFO mode is not selected, push [VFO] to select it
¢ Frequency changes according to the selected tuni
steps. (p. 18)
¢ Pushing [4] or [W] for more than 0.5 sec. activates
scan. If this happens, push [4] or [WV] again to stop
NOTE: 1 MHz steps cannot be used via the [A}/[
4, switches.
Ws