Icom IC-207H - Page 27

B Receiving
) Push [PWR] for 1 sec. to turn power ON.
) Push [BAND] to select a band.
) Set the audio level.
=> Push [MONI] to open the squelch.
| “» Rotate the [VOL] control to adjust the audio output level.
_ > Push [MONI] again to close the squelch.
) Set the squelch level.
=> Rotate [SQL] fully counterclockwise in advance.
» Rotate [SQL] clockwise until the noise just disappears.
> When interference is received, rotate [SQL] clockwise
again for attenuator operation.
) Set the operating frequency. (pgs. 15-19)
) When receiving a signal on the set frequency, squelch
opens and the transceiver emits audio.
e “BUSY” appears and the S/RF indicator shows the relative signal
strength for a received signal.
NSE
td
tn
sired
ES
a
oS
When receiving a signal on VHF.
BASIC OPERATION
The volume and squelch levels can be adjusted via the mi-
crophone. However, levels return to the front panel setting
when power is turned OFF or a front panel control is adjusted.
—_ Push [PWR] on the transceiver for 1 sec. to turn
BAND power ON.
Set the audio levels.
=» Select the desired band.
Push [OMONI], then push [®WVOL] or
Ne [OAVOL] to adjust the audio level.
> Push [OMONI] again to close the squelch.
VOL [3]Set the squelch level using [®WSQL] or
\V) [OASQL], if desired.
Set the operating frequency. (pgs. 15-19)
Susy
- af ae
HI nto 4 103 HI cm ots ae
Lt ee 4 alo i
Appears while setting volume Appears while setting squelch
VY CONVENIENT
RF attenuator: The transceiver has an RF attenuator related
to the [SQL] setting. The attenuator is automatically activated
when [SQL] is rotated further than the 12 o’clock position.
Approx. 10 dB attenuation is obtained at full rotation.
4 aE
<=
”
my
oO
en
Lu