Icom IC-207H - Page 32

5 REPEATER OPERATION
SIMP
[1] Push [BAND] to select the desired band, if nec-
essary.
Set the receive frequency (repeater output fre-
quency). (pgs. 15-19)
Push [®DUP-] to select -— duplex; push
[®DUP+] for + duplex.
Push [FUNC] then [®TONE] to turn ON the
subaudible tone encoder according to repeater
requirements.
¢ Refer to p. 26 for tone frequency setting.
e When the repeater requires a different tone system,
see at right.
Push and hold [PTT] to transmit.
[6] Push and hold [OMONI] to check whether the
other station’s signal can be directly received.
Release [PTT] to receive.
To return to simplex operation, push [OSIMP].
[9] To turn OFF the subaudible tone encoder, push
[FUNC], then [OT-OFF].
© DTMF tones
—
DTMF S
Push [DTMF-S], then push the keys of the desire
DTMF digits.
¢ The function indicator lights green.
¢ 0-9, A-D, *(E) and #(F) are available.
Cancel the DTMF memory encoder function in a
vance. (p. 48)
¢ Push [DTMF-S] again to return the keypad to norr
function control.
¢ The transceiver has 14 DTMF memory channels 1
autopatch operation. See p. 46 for details.
© 1750 Hz tone
A 1750 Hz tone is required to access most European r
peaters. The microphone has 1750 Hz tone capability.
(\ Push [FUNC].
TONE-1
¢ The mode indicator lights orange.
\/ Bi Push [®TONE-1] to transmit a 1750 Hz tor
a
TONE-2
call signal for 0.5 sec.; push and hold [OTONI
2] to transmit a 1750 Hz tone call signal for <
arbitrary period.
¢ The mode indicator goes out automatically. |
¢ The optional HM-90 also has 1750 Hz tone capabili