Icom IC-207H - Page 31

fi Accessing a repeater
) Push [BAND] one or more times to select the desired band.
) Set the receive frequency (repeater output frequency).
(pgs. 15-19)
)Push and hold @@g for 1 sec., one or more times, to se-
lect — duplex or + duplex.
¢ “DUP —” or “DUP” appears to indicate the transmit frequency for
minus shift or plus shift, respectively.
¢ When the auto repeater function is turned ON, (available for the
U.S.A. version only), steps @, @ are not necessary. (p. 31)
) Push [TONE] one or more times to turn ON the subaudible
tone encoder, according to repeater requirements.
¢ Refer to p. 26 for tone frequency settings.
e When the repeater requires a different tone system, see the page
at right.
) Push and hold [PTT] to transmit.
¢ The displayed frequency automatically changes to the transmit
frequency (repeater input frequency).
* The operating condition is automatically programmed into a
scratch pad memory. See p. 36 for details.
REPEATER OPERATION
| + If “OFF” appears, confirm the offset frequency. (p. 27)
© Release [PTT] to receive.
@ Push [MONI] to check whether the other station’s transmit
signal can be directly received or not.
To return to simplex, push @21@B for 1 sec., once or twice,
to clear the “DUP” indicator.
@ To turn OFF the subaudible tone encoder, push [TONE]
one or more times until no tone indicators appear.
5
<=
”
aT
Oo
z
Lu