Icom IC-207H - Page 34

© REPEATER OPERATION
use SET MODE
@ Offset frequency
The display shows that a
0.6 MHz (600 kHz) fre-
quency is set.
Separate setting for each band
@ Push [BAND] to select the desired band.
@ Select the mode/channel you wish to set the offset fre-
quency to, such as VFO mode or memory/call channel.
e The offset frequency can be independently programmed into
each mode or channel.
@® Push [SET] one or more times until “DUP” appears and
flashes as shown above.
¢ Pushing [MONI] reverses the order of selection.
¢ Cancel the DTIMF memory encoder in advance. (p. 48)
@ Rotate the tuning dial to set the desired frequency.
¢ Selectable step increment is the same as the preset tuning step.
(p. 18)
e Use [V/MHZ] for quick MHz setting.
© Push [V/MHz] to exit set mode.
4
CR Q@Q{
Push [BAND] to select the desired band, if ne
essary.
Set the mode/channel you wish to set the of
set frequency to, such as VFO mode or men
ory/call channel. |
¢ The offset frequency can be independently pr
grammed into each mode or channel.
Push [®SET] one or more times until “DUP” a
pears and flashes as shown at left.
e Pushing [OENT] reverses the order of selection.
¢ Cancel the DTMF memory encoder in advanc!
(p. 48)
Push [A] or [W] to select and set the desire
frequency.
¢ Selectable step increment is the same as the pres
tuning step. (p. 18)
e Pushing and holding [4] or [W] changes the fri
quency continuously.
[5] Push [@CLRA] to exit set mode.
:
NOTE: The offset frequency can be set in a memory chal
nel temporarily. However, the set contents are cleare
once the memory/call mode is selected. To store the offs
frequency permanently, overwrite the channel informatio.