Icom IC-207H - Page 35

B Auto repeater
(U.S.A. version only)
he U.S.A. version automatically activates the repeater set-
ngs (DUP or DUP-— and tone encoder ON/OFF) when the
perating frequency falls within the general repeater output
equency range and deactivates them when outside of the
ange.
> Setting the auto repeater function ON/OFF
) Push [PWR] to turn power OFF.
) While pushing [SET] (far right switch), turn power ON to
enter initial set mode.
) Push [SET] one or more times until the “rPt” display ap-
pears as shown below.
eee. a
pag ae Ne | t) | a i 7s (
Auto repeater function is ON,
tone encoder is OFF.
uto repeater function is
ined OFF
) Rotate the tuning dial to turn the auto repeater function to
it, re or OFF.
e “r1”: auto repeater is ON, tone encoder is OFF;
“r2”: auto repeater is ON, tone encoder is ON.
) Push [PWR] momentarily to exit initial set mode.
usine INITIAL SET MODE
REPEATER OPERATION 5
° ama range and offset direction
_. DUPLEX DIRECTIO
ary camry ae ae ar) Pateaboears
146.610-146.995 MHz PP
147.000—147.395 MHz “DUP” appears
442.000-444.995 MHz “DUP” appears
447.000—449.995 MHz “DUP-” appears
ENGLISH