Icom IC-207H - SECTION 10 BLOCK DIAGRAM

m6 3s MEMORY OPERATION
— General description
The transceiver has 150 regular memory channels, 10 scan
edge memory channels (5 pairs) plus 2 call channels (by de-
fault C1 is for VHF and C2 is for UHF, however both can be
set to VHF or both to UHF as desired); each of these can be
individually programmed with the following data.
¢ Operating frequency (pgs. 15-19)
¢ Duplex direction (DUP or DUP-) and its offset frequency
(pgs. 24, 25, 27)
¢ Subaudible tone encoder or tone squelch and its tone fre-
quency (pgs. 24—26)
¢ Skip information* (p. 42)
“Except for the scan edge memory channels.
—@ Memory channel selection
© Using the tuning dial
@ Push [M/CALL] once or twice to display “@B”.
@ Rotate the tuning dial to select the desired memory chal
nel.
¢ Only programmed memory channels can be selected.
© Using [A]/[V] switches
Push [BAND] to select the desired band, if nev
essary.
Push [MR] to select memory mode.
[a Push [A] or [¥] several times to select the d
sired memory channel.
e Pushing [4]/[¥] more than 0.5 sec. activates a sca
¢ If ascan is activated, push [A] or [W] again to stop
© Using the keypad
41] Push [BAND] to select the desired band, if ne
essary.
[2] Push [MR] to select memory mode.
[3] Push [OENT] to activate the keypad for nt
ue
ENT
\c) meral input.
[4] Push 2 appropriate digit keys to input a char
nel number.
¢ When inputting non-programmed channel numbe
the previous memory channel appears.
* To select scan edge channels, “®” and “®” can t
used for A and b respectively.