Icom IC-207H - Page 37

MEMORY OPERATION 6
| Programming a memory channel
O mode settings, including the set mode contents such as programmed.
baudible tone frequency, etc., can be programmed into a * Memory channels not yet programmed are blank.
»mory channel. @ Push [S.MW] for 1 sec. to program.
¢ 3 beeps may sound.
Set the desired frequency in VFO mode: e Memory channel number automatically advances when continu-
=> Push [V/MHz] to select VFO mode. ing to push [S.MW] after programming.
=> Set the frequency using the tuning dial.
=> Set other data (e.g. tone frequency, etc.) if required. ¥ CONVENIENT
Push [S.MW] momentarily. Memory programming can be performed in versatile ways
° “@B” and the memory channel number flash. e.g. memory channel to the same (or different) memory chan-
Rotate the tuning dial to select the memory channel to be nel, memory channel to the call channel, etc.
=XAMPLE]: Programming 145.870 MHz into memory channel 20 via the remote controller.
Push and (0) Rotate for setting Push
\
ys
soa
otc.
Cw
momentarily
‘Gat for 1 sec. and continue pushing |1/1i=_>
ENGLISH