Icom IC-207H - SECTION 11 VOLTAGE DIAGRAM; 11-1 CONTROL UNIT

31
6 MEMORY OPERATION
—@ Programming a memory channel via the microphone
Memory channel programming can be performed [3] Push [FUNC] then [©MW] momentarily.’
via the microphone. Select the memory channel to be programmed:
» Push [A] or [¥] to select the memory channel (direct num
{1 Push [BAND] to select the desired band, if necessary. input cannot be used).
Set the desired frequency in VFO mode: Push [FUNC] then [®MW] for 1 sec. to program.
“> Push [VFO] to select VFO mode. > 3 beeps may sound and the VFO contents (including the s
> Set the frequency using the keypad. audible tone frequency, etc.) are programmed.
=» Set other data (e.g. offset frequency, duplex direction, subaudi- “> Memory channel number advances when continuing to pi
ble tone encoder ON/OFF and its frequency), if required. [MW] after programming.
[EXAMPLE]: Programming 145.870 MHz into memory channel 20 via the microphone.
QVYEIE) =
iia (9). (a) (xx) cplien ‘get neh momentarily
DUP+ (cx 7)
Mw
Push (¥ (0) a} Push then for 1 sec. and
continue pushing | 1 1=>