Icom IC-207H - Page 39

a
Transferring memory
| contents
his function transfers a memory channel’s contents into a
FO (or another memory/call channel). This is useful when
parching for signals around a memory channel frequency
nd for recalling the offset frequency, subaudible tone fre-
ency, etc.
Push ‘Gaal for 1 sec.
| =» Select memory mode by pushing [MICALL} once or twice (“@ip”
appears).
| =» Rotate the tuning dial to select the memory channel.
Push [S.MW] momentarily, then rotate the tuning dial to se-
lect another memory channel to transfer.
} ¢ To transfer to the VFO, push and hold [(S.MW)MW] instead of
pushing momentarily.
Push and hold [(S.MW)MW] to transfer when a momentary
» push was used in the previous step.
MEMORY OPERATION 6
Push [BAND] to select the desired band, if nec-
_ essary.
Select the memory channel to be transferred:
=» Push [MR] to select memory mode.
=» Push [A] or [VW] to select the memory channel; or
push [©ENT] then push the desired memory chan-
nel number (2 digits) to select the memory chan-
nel directly.
Push [FUNC] then [©MW] momentarily, then
push [A] or [W] to select another memory
channel to transfer.
¢ To transfer to the VFO, push [FUNC] then push and
~ hold [@MW] instead of pushing momentarily.
Push [FUNC] then [@MW] for 1 sec. to transfer
when a momentary push was used in the previ-
ous step.
ENGLISH