15
8
RING FUNCTIONS
7
8
■ Smart-Ring
The ring function has an answer back feature. This allows confir-
mation of whether or not a call has reached the receiving party even
if the operator is temporarily away from the transceiver.
q Set the same group channel
number for all of the group
transceivers. (See p. 12)
w While pushing [PTT], push [Y] .
• A beep is emitted and “” blinks
on the display.
e Release the [PTT].
• When a member of a specific
group answers a call, the trans-
ceiver emits beep tones for
10 sec. and blinks “
.
”
• When no answer comes back, the transceiver emits short faint
beep tones.
r Push [PTT] to answer and to stop the beeps and flashing.
NOTE: This function is available only when the called station has
set the same group number and the same operating channels
as you.
■ Call-Ring
Sends the ring tones during trans-
mit mode.
➥ While pushing [PTT], push [Z]
to send a ring tone.
• The ring tone is emitted while
pushing [Z].
• The microphone signal is auto-
matically cut while pushing [Z].
To Next Page
Loading...
