Need help?Do you have a question about the Icom IC-41S and is the answer not in the manual?
General| Modulation | FM |
|---|---|
| Voltage | 7.4 V DC |
| Type | Handheld Transceiver |
| Sensitivity | 0.25 μV (at 12 dB SINAD) |
| Selectivity | 70 dB |
| Power Output | 5 W |
| Operating Voltage | 7.4 V |
Emphasizes the importance of reading all operating instructions before use.
Advise to listen to the channel before transmitting to avoid interference.
Specifies emergency channels and notes on radio behavior when switched off on these channels.
Provides critical safety warnings regarding transceiver handling, transmission, and audio levels.
Advises against exposure to extreme temperatures, water, and unauthorized modifications.
Overview of the transceiver's front panel, highlighting key buttons and indicators.
Explains the operations and functions of the 'Top' key in different modes.
Describes the various functions and operations controlled by the 'Side1' key.
Details the functions of the PTT, channel up/down, and volume control keys.
Explains the information displayed on the transceiver's screen.
Details the operations of the Scan/Tag key for scanning and channel tagging.
Explains the functions of the O•G•P/RS key for scan mode selection and repeater scan.
Describes the functions of the Priority/Set-P and LOW/Power/Lock keys.
Explains the meaning of various indicators displayed on the transceiver screen.
Details the remaining indicators on the transceiver display, including Bell, Quiet, and Battery.
Describes the alphanumeric display for channel numbers, names, and mode settings.
Explains the Function and Low Power indicators on the display.
Details the indicators related to different scan modes (Open, Group, Priority).
Instructions for turning the transceiver power ON and initial setup.
Guide for selecting the correct battery type when powering on the transceiver.
How to select operating channels and configure zone types.
Detailed steps for receiving signals and transmitting audio with the transceiver.
Step-by-step guide on how to transmit audio and important microphone usage tips.
Introduction to Set Mode for customizing transceiver operations and settings.
Step-by-step guide on how to enter, navigate, and exit Set Mode.
Explains how repeaters extend operational range by re-transmitting signals.
Guide on selecting repeater output channels and transmitting via a repeater.
Explains tone squelch for silent standby and receiving calls from specific group members.
Introduction to SelCall operation for selective individual or group calling.
Important safety warnings concerning the handling, charging, and disposal of batteries.
Specific warnings and precautions related to the battery charging process.
To Next Page
