27
7
SELCALL OPERATION
7
t Push [CH Up] or [CH Down] to set the desired code.
• Select “❋” when group code is set.
y Push (TX Code CH) to set the digit and the editable
digit move to right automatically.
u Repeat step t and y to input all allowed digits.
i After setting the last digit, push
(TX Code CH) to set
the code and return to the TX code channel selection
mode.
o Push [PTT] to transmit to the selected TX code channel,
or push
(TX Code CH) to set the selected TX code
channel and return to the stand-by mode.
NOTE: The TX code editable digit can only be set/changed
with the optional CS-41S
CLONING SOFTWARE
.
DTransmitting an individual call
➥ Push [Top] (Function) to enter the function mode, then push
and hold
(Call) for 2 sec. to transmit.
To Next Page
Loading...
