Icom IC-41S - Receiving Calls

28
7
SELCALL OPERATION
■ When receiving a call
D Receiving an individual call
q When receiving an individual call (default setting);
• “PiRo” beeps sound.
• The received code channel name is displayed.
• “ë” and the displayed channel name blink, and the SelCall mute
is released when the quiet mode is activated.
w While pushing and holding [PTT], speak into the micro-
phone at a normal voice level.
NOTE: When the ID decode function is turned ON, the re-
ceived ID code is displayed instead of the channel name,
and memorised into the transceiver. The ID decode func-
tion can be turned ON using the optional CS-41S
CLONING
SOFTWARE
.
• RX code means the Receiving SelCall code. Max. 8 RX
code channels can be pre-programmed into the trans-
ceiver using the CS-41S.
• You can set the transceiver’s condition when receiving an
individual call using the CS-41S. See the help file for set-
ting details.
Recall the memorised RX code:
q Push [Top]
(Function) to enter the function mode, then push
and hold
(ID-MR) for 2 sec. to display the memorised
RX code.
w Push [CH Up] or [CH Down] to select the desired RX code.
e Push [Top]
(Function) to enter the function mode, then push
and hold
(Call) for 2 sec. to transmit the code on the
selected channel.
DReceiving a group call
q When receiving a group call (default setting);
• “PiPi” beep sounds.
• “ë” and “GROUP” blink, and the SelCall mute is released when
the quiet mode is activated.
w While pushing and holding [PTT], speak into the micro-
phone at a normal voice level.
You can set the transceiver’s condition when receiving a
group call with the CS-41S. See the help file for setting de-
tails.
Blink
Blink