30
8
OTHER FUNCTIONS
These functions have an answer back feature, and allow you
to confirmation of whether or not a call has reached the
receiving party even if the operator is temporarily away from
the transceiver. The Smart-Ring is for manual, and the ATS
is for automatic confirmation.
D Smart-Ring
q Set the same CTCSS tone frequency for all of the group
transceivers and turn the tone squelch ON. (pgs. 22, 34)
w Push [Top]
(Function) to enter the function mode, then push
(S-Ring) to send the Smart-Ring call.
• “”appears.
• When a member of a specific group answers a call, “ë” and
“FOUND” blink.
• When no answer back is received, the transceiver emits short
failure beep tones and “FAILD” appears.
e Push [PTT] to answer and to stop blinking.
NOTE: The Smart-Ring function is available only when the
called station has set the same CTCSS tone frequency
and the same operating channel as you.
NOTE:
• The setting at left is for the calling station only. A called
party automatically sends an answer back signal without
any pre-settings. All IC-41S’s operating on the same op-
erating channel will answer back to the call in the sur-
roundings communications area.
• When RX channel is selected, “N/A” appears.
DATS
q Push [Top] (Function) to enter the function mode, then push
and hold [Side1]
(ATS) for 2 sec. to turn the ATS function ON.
• When RX channel is selected, error beep is emitted.
• The transceiver starts to send a searching signal every 60 sec.
• “”appears and “”starts blinking on the display when the
function is activated.
• When the transceiver receives an answer back signal, “”stays
on the display until the next search transmit.
• If no reply is received, “”blinks until the next search transmit.
w Push [Top] (Function) to enter the function mode, then push
and hold [Side1]
(ATS) for 2 sec. to turn the ATS function
OFF.
To Next Page
Loading...
