34
9
SET MODE
■ Set mode
Set mode allows you to change seldom used common set-
ting for the transceiver, or individual setting for the operating
channel. In this case you can “customize” transceiver opera-
tion to suit your preferences and operating style.
Available functions may differ depending on the pre-setting
via the optional CS-41S
CLONING SOFTWARE
.
NOTE: Set mode can be accessed via the [Top]
(Set Mode)
key operation after turning power ON with [CH Up] and [CH
Down] (p. 15.) In this case, all set mode items are available.
DSet mode operation
q Push and hold [Top] (Set Mode) for 2 sec. to enter Set mode.
• When no key is pushed for 30 sec. the transceiver returns to nor-
mal operation.
w Push [Top]* to select the desired item, if necessary.
e Push [CH Up] or [CH Down] to select the desired condi-
tion of the item.
r Rotate [VOL] to turn the power OFF, or push and hold
[Top]
(Set Mode) for 2 sec. to exit set mode.
*Regardless of the assigned key function.
• Own ID
• Lock-out • TOT • Power Save • Signal Moni • Battery Voltage
• Squelch Level • CTCSS/DTCS • Auto Power OFF • Backlight
• Mic Gain
• Beep Level
• Beep
• Roger Beep
• Scan Restart
• Scan Stop Timer
Starting item
: Push [Top]
To Next Page
