Icom IC-4088SR - I Selecting the Operating Channel

9
4
BASIC OPERATION
4
■ Selecting the operating channel
Push [Y] or [Z] keys several times
until the desired operating channel
number appears on the display.
• While pushing and holding [Y] or
[Z] keys, the displayed channel
changes continuously until chan-
nel number “1” appears.
To keep the automatic selection,
release the [Y] or [Z] keys then
push and hold them again.
• When displayed channel stops at channel number “1,” a beep is
emitted.
NOTE:
• The transceiver has 8 operating frequency channels.
• The selected channel is memorised when the transceiver is
turned off.
[Y]
[Z]
IC-4088SR.qxd 03.9.2 20:45 Page 9 (1,1)