Icom IC-410PRO - Supplied Accessories

iii
PRECAUTIONS (Continued)
This device complies with Standard Australia
Specication No. AS/NZS 4365-2011.
DO NOT use harsh solvents such as benzine or alcohol to
clean the transceiver, as they will damage the transceiver’s
surfaces. If the transceiver becomes dusty or dirty, wipe it
clean with a soft, dry cloth.
DO NOT modify the transceiver. The transceiver warranty
does not cover any problems caused by unauthorized
modication.
DO NOT use or place the transceiver in direct sunlight or in
areas with temperatures below –30°C or above +60°C.
DO NOT place the transceiver in excessively dusty
environment.
DO NOT place the transceiver against walls or putting
anything on top of the transceiver. This will obstruct heat
dissipation.
BE CAREFUL! The transceiver will become hot when
operating it continuously for long periods of time.
MAKE SURE to turn OFF the transceiver power before
connecting any supplied/optional equipment.
USE only Icom microphones (supplied or optional). Other
manufacturer’s microphones have different pin assignments
and may damage the transceiver if attached.
Icom is not responsible for the destruction or damage to the
Icom transceiver, if the malfunction is because of:
• Force majeure, including, but not limited to,
res,earthquakes, storms, oods, lightnings, or other
naturaldisasters, disturbances, riots, war, or radioactive-
contamination.
• The use of Icom transceiver with any equipment that is
not manufactured or approved by Icom.