Icom IC-410PRO - Channel Selection

u [MONI] KEY*
* Different functions may be assigned by your dealer.
Normal mode
➥ Push to turn the Monitor (open squelch) function ON
or OFF.
➥ Hold down for 2 seconds to activate the following
functions in sequential order.
Function mode
➥ Push to turn the ATS (Automatic Transponder System)
function ON or OFF.
➥ Hold down for 2 seconds to transmit a Smart ring
signal.
i MICROPHONE CONNECTOR
Connects the supplied or an optional microphone.
2
1
PANEL DESCRIPTION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
t [DUP] KEY*
* Different functions may be assigned by your dealer.
Normal mode
➥ Push to select the Duplex (repeater access) and
Simplex (no repeater access) mode.
➥ Hold down for 2 seconds to electronically lock all keys
except [DUP], [FUNC], and [MONI].
➥ Hold down for 2 seconds again to unlock all keys.
Function mode
➥ Push to select the Priority channel, if set.
➥ Hold down for 2 seconds to set the selected channel
as the Priority channel.
➥ Hold down for 2 seconds again to return the Priority
channel to a Normal channel.
y [SCAN] KEY*
* Different functions may be assigned by your dealer.
Normal mode
➥ Push to start or stop a scan.
➥ Hold down for 2 seconds to tag or untag the displayed
channel.
The tagged channels will be scanned.
Function mode
➥ Push to enter the Selcall Code Channel Selection
mode.
➥ Hold down for 2 seconds to transmit the selected
Selcall code, when a CB channel is selected.
TSQL
(Tone squelch)
Only receives calls with the same tone
squelch code.
TSQL ë
(Pocket beep)
Pocket beep function is ON.
(No tone operation)
“TSQL
ë ” disappears.