Icom IC-701

etamemnenattanmaaaatanieaegeheenanaatpiate Aten ithaca ma ROA NIRCO ate
7-2-2 VXO FREQUENCY ADJUSTMENT
Connect the input terminals of the frequency counter
across CP1 and ground of the “‘A’”’ unit and perform the
following adjustments.
(a) Place the set in receive in the CW (P.B. TUNE control
centered) and adjust coil L1 for a frequency of
19.76330MHz.
(b) Then set the mode to USB or LSB and adjust R28
VXO Frequency Adjustment
L1
Adjust core for
19.7633MHz
in CW mode
CP1
counter
7-2-3 AGC SENSITIVITY AND S METER
ADJUSTMENT
With the receive frequency set to 14MHz, mode to USB
AGC fast, RF GAIN fully clockwise, connect the signal
generator to the antenna connector. MAKE SURE THAT
1F NOT, THE
THE SET IS IN THE RECEIVE MODE!!
GENERATOR WILL BE DAMAGED!!
L13
D20
(A unit)
Sensitivity and S meter adjustment
Connect frequency
(a)
on the front inside of the set to obtain 19.75970MHz
with the P.B. TUNE knob turned fully counter-
clockwise. Set P.B. TUNE knob to the center
position and adjust R27 for 19.7615MHz. R28 and
R27 adjustments interact so repeat several times unit
no further change is noted. Set P.B. TUNE knob
fully clockwise. If previous adjustments are correct,
frequency should read 19.7631MHz.
A27 Adjust for
19.7597MHz
described in (b)
AW,
eA,
a4
Adjust the signal generator output to minimum and
connect the multimeter set to the 10 Volt DC range
across the plus lead of D20 in the “A” unit and
ground. Make sure no signal is applied to the set.
Adjust R168 in the “A” unit to get 4.0 Volts on the
multimeter.
¢ it R168
eo = —__. Adjust to get 4.0V on the
a multimeter (a)
se R153
Adjust to get 200mV on the
AC millivoltmeter (c)
R44
Connect AC millivoltmeter (c)
R16
Adjust to make the S meter read S=9+60dB
R22 Adjust to make the S meter read S=1.
neste nisin eRe tit in NR tanh POS nee