Icom IC-701 User Manual

SECTION
4
OPERATING
CONTROLS
4-1 FRONT PANEL
@ DIAL LOCK INDICATOR LED
@ FREQUENCY DISPLAY
@ DIAL TS INDICATOR LED
@ TRANSMIT INDICATOR LED
@ MULTI-FUNCTION METER
78 5 ALC Po
ef ee COMP 4.4 “io
35 Sm!
> aT
@
BAND
SWITCH
en
mr
(.
@®
METER
SELECT
whe
SWITCH
rd
@ POWER SWITCH
® PHONES JACK—33
® MIC CONNECTORS
/ 4
WB. TINE /’
fj i
@ COMP (SPEECH
PROCESSOR)
CONTROL
@® MIC GAIN CONTROL
@ AF GAIN CONTROL
@ RF GAIN CONTROL
@ MODE SELECT
SWITCH
(PASS BAND TUNING
( VFO SWITCH
@ RIT CONTROL
1. BAND SWITCH
The BAND SELECT SWITCH is a 7 position rotary switch
used for selecting one of the 6 Amateur bands covered by
the IC-701 with a 7th position for external control.
The selectable bands are 1.8MHz, 3.5MHz, 7MHz, 14MHz,
21MHz and 28MHz. In the EXT position, the band can
be selected remotely. However, the switch should not be
put in the EXT position without having the remote control
connected. This will cause the rotary switch to rotate
continuously and may cause excessive wear or damage.
2. MULTI-FUNCTION METER
With the {C-701 in the receive mode, this meter acts as an
S meter regardless of the position of the meter select
—-6-—-
11c-70O8
8 RATB -
. Lo SBR pit NB oRaC
ee,
@ DIAL LOCK BUTTON
@ TUNING CONTROL
KNOB
@ TUNING SPEED BUTTON
12 AGC SWITCH
@ ATTENUATOR SWITCH
(® NOISE BLANKER SWITCH
(9 VOX SWITCH
1) RIT SWITCH
@ TRANSMIT/RECEIVE SWITCH
switch. Signal strength is indicated on a scale of $1-S9
and $9+20dB to S9+60dB.
In the transmit mode, the meter has 5 functions as outlined
below which are selected by the meter select switch.
3. METER SELECT SWITCH
In the transmit mode the meter has 5 functions.
1. Ve Indicates the collector voltage of the final
transistors.
2. Ic Indicates the collector current of the final
transistors.
3. Po Indicates the relative output power. SWR can
eenicnenne eines te cca area ah ete ast
at ea ORthtee am iat ne nlite nee EEE Ane aoe emabaeSiNeS |

Icom IC-701 Specifications

General

Brand	Icom
Model	IC-701
Category	Transceiver
Language	English