Icom IC-706MKIIG - Important Cautions for Servicing; Key Repair Notes and Precautions

Icom IC-706MkIIG Operation Guide
KE1RI, Idlenot.com Page 2
S1-S4 Manual p. 4
S1
Memo Pad – quick
temp. memory, 5 or 10
available
MW – Memory Write
Press 2 sec. to save
freq. to mem. displayed
MPW-Memory Pad
Write: Push to write
10 Memories avail.
MPR-Memo Pad Read
Push to cycle 10 pad
memories
S2
Scan Functions
SCN-Scan
Starts & Stops scan; set
SQL open or closed 1
st
.
Resume setting controls
Resume in 10 sec is
default (resume ON)
PRI-Priority Watch
In VFO mode set a freq.
Close squelch.
Dial in mem. chan. to be
watched
Press PRI (F2) to begin
& end.
V/M Toggle between
VFO and Memory
Mode; rotate (17) M-CH
to choose memories
S3
B. S. R. Band Stacking
Register; quick band
change function. See p.
4 of manual
14
Press and hold to
change band.
7
Store here the 3 bands
you use most frequently
144
Allows quick jump to
band with one press.
S4
Digital Signal Processing
ANF-Auto Notch Filter
Toggle On/Off
NR-Noise Reduction
NRL-Noise Reduc. Level
Press to choose level by
rotating M-CH dial
G1-G4
G1
Band Scope : Push F-1 to select step (0.5-100kHz).Push F-3 for sweep start/stop.Rotate main
dial to align with freq. peak you want to tune to. F-3 sweep agn., F-2 return to orig. freq.
G2
SWR Plot Measurement; hold F-1 to choose pitch; push & hold F-2 for step; Push F-3 and then
push and release PTT until each bar displays; 1 or 2 rows of display is under 1.5:1 SWR
G3
Tx Freq. – Press F-3 (T) & then M-CH dial to choose TX freq.
G4
Memory Names: Use M-CH dial to choose memory.
Editing Memory Names: Choose ‘E’ (F-3); rotate main dial to select characters.
F-3>next F-1>back F-2>space. Push ‘Menu’ to exit.