Icom IC-7600

4 - 19
4-9-1 SOFTWARE ADJUSTMENT (TRANSMIT) (continued)
ADJUSTMENT
ADJUSTMENT
ITEM
OPERATION VALUE
PREPARATION 1
–
1) Connect an Audio Generator and AC Millivoltmeter to the [MIC]
connector on the FRONT panel, and set it as;
Frequency : 1.5 kHz
Level : 10 mV
2) Connect an RF Power meter (terminated) to [ANT1].
3) Connect a Dummy Load (SWR=2; 100
Ω
) to [ANT2].
4) Disconnect the power cable from the transceiver, and connect
an DC Ammeter (30 A) between the power supply and
transceiver.
–
POWER METER
(HF BAND)
1 [POWER HF/50M
0%]
• Push [F-6] (SET).
–
2
[POWER HF Tuner]
1) Adjust the TX power using MAIN DIAL.
2) Push [F-6] (SET).
10 W
3
[POWER HF 10%]
1) Adjust the TX power using MAIN DIAL.
2) Push [F-6] (SET).
10 W
4
[POWER HF 50%]
1) Adjust the TX power using MAIN DIAL.
2) Push [F-6] (SET).
50 W
5 [POWER HF APC
Low Volt]
1) Adjust the TX power using MAIN DIAL.
2) Push [F-6] (SET).
80 W
6
[POWER HF 100%]
1) Adjust the TX power using MAIN DIAL.
2) Push [F-6] (SET).
100 W
POWER METER
(50MHz BAND)
1
[POWER 50M Tuner]
1) Adjust the TX power using MAIN DIAL.
2) Push [F-6] (SET).
10 W
2
[POWER 50M 10%]
1) Adjust the TX power using MAIN DIAL.
2) Push [F-6] (SET).
10 W
3
[POWER 50M 50%]
1) Adjust the TX power using MAIN DIAL.
2) Push [F-6] (SET).
50 W
4
[POWER 50M 100%]
1) Adjust the TX power using MAIN DIAL.
2) Push [F-6] (SET).
99 W
POWER-DOWN
SETTING
1 [POWER for Power
Down HF/50M]
1) Adjust the TX power using MAIN DIAL.
2) Push [F-6] (SET).
50 W
ALC METER 1 [ALC] • Push [F-6] (SET). –
DRIVE GAIN 1 [DRIVE] • Push [F-6] (SET). –
Vd METER 1 [Vd 13.8V] • Push [F-6] (SET). –
Id METER 1 [Id 0A] • Push [F-6] (SET).
–
2
[Id 10A]
1)
Adjust the driving current using MAIN DIAL.
2) Push [F-6] (SET).
10 A
3
[Id 15A]
1) Adjust the driving current using MAIN DIAL.
2) Push [F-6] (SET).
15 A
SWR METER 1
[SWR]
• Push [F-6] (SET).
(Returns to "ADJUSTMENT MODE.")
–
for free by
RadioAmateur.eu