Icom IC-A24 Service Manual

3 - 1
SECTION 3 DISASSEMBLY INSTRUCTION
E
E
LOGIC/RF unit
Front panel
A
D
B
F
J4
J4
C
J
I
J
LOGIC unit
RF unit
J
H
G
RF unit
L
M
L
K
Be careful not to break and lost the sealing washer.
• REMOVING THE CHASSIS PANEL
1 Remove the Jack cap A.
2 Remove [VOL] knob B and [DIAL] knob C.
3 Unscrew the ANT nut D.
4 Unscrew 3 screws E.
5 Disconnect the connector F from J4 and remove the
LOGIC/RF unit from the Front panel.
• REMOVING THE LOGIC UNIT
1 Remove the main seal G.
• REMOVING THE RF UNIT
1 Unsolder 2 points K.
2 Unscrew 6 screws L.
3 Unscrew 2 screws M and remove the RF unit from the
chassis unit.
2 Unsolder 1 point H.
3 Unscrew 2 nuts I.
4 Unscrew 3 screws J and remove the LOGIC unit from
the RF unit.
Continue to right above.

Icom IC-A24 Specifications

General

Channel Spacing	25 kHz
Operating Voltage	7.2 V DC
Mode	AM
Voltage	7.2 V DC
Frequency Range	118.000-136.975 MHz
Output Power	5.0 W (PEP), 1.5 W (carrier)
Battery Life	8 hours (with BP-210N)
Number of Memory Channels	200 channels
Current Drain (Transmit)	1.5 A
Modulation	AM
Number of Channels	200 channels
Current Drain (Receive)	300 mA (internal SP), 500 mA (external SP)