Icom IC-F1020 - Table of Contents

ii
TABLE OF CONTENTS
IMPORTANT ........................................................................ i
EXPLICIT DEFINITIONS ..................................................... i
CAUTIONS ........................................................................... i
TABLE OF CONTENTS ...................................................... ii
1 PANEL DESCRIPTION ............................................. 1–5
■ Front panel ............................................................................ 1
■ Programmable function keys ................................................ 2
■ Function display .................................................................... 5
2 OPERATION ............................................................. 6–8
■ Turning power ON ................................................................. 6
■ Channel selection ................................................................. 6
■ Receiving and transmitting ................................................... 7
D Transmitting notes ........................................................... 7
D DTMF transmission ......................................................... 8
3 CONNECTION AND INSTALLATION .................... 9–12
■ Rear panel and connection ................................................... 9
■ Unpacking ........................................................................... 10
■ Mounting ............................................................................. 11
■ Separation .......................................................................... 11
■ Optional UT-105 installation ................................................ 12
4 OPTIONAL SmarTrunk II™ OPERATION ........... 13–15
■ SmarTrunk II™ and conventional modes ............................ 13
■ SmarTrunk II™ operation .................................................... 13
5 OPTIONS .................................................................... 16
DO NOT use or place the transceiver in areas with tem-
peratures below –30°C (–22°F) or above +60°C (+140°F) or,
in areas subject to direct sunlight, such as the dashboard.
AVOID operate the transceiver without running the vehicle’s
engine. The vehicle’s battery will quickly run out if the trans-
ceiver is in transmission while the vehicle’s engine OFF.
AVOID placing the transceiver in excessively dusty envi-
ronments.
AVOID placing the transceiver against walls. This will ob-
struct heat dissipation.
AVOID the use of chemical agents such as benzine or al-
cohol when cleaning, as they damage the transceiver sur-
faces.
BE CAREFUL! The transceiver will become hot when
operating continuously for long periods.
For U.S.A. only
CAUTION: Changes or modifications to this transceiver,
not expressly approved by Icom Inc., could void your authority
to operate this transceiver under FCC regulations.