Icom IC-F6062 Instruction Manual

8
2
BASIC OPERATION
■ Turning power ON
q Hold down [ ] for 1 second to turn the power ON.
w If the transceiver is programmed for a start up password,
input the digit codes as directed by your dealer.
 •Thekeysasbelowcanbeusedforpasswordinput:
The transceiver detects numbers in the same block as identical.
Therefore “01234” and “56789” are the same.
eWhenthe“PASSWORD”indicationdoesnotclearafterin-
putting 6 digits, the input code number may be incorrect.
Turn the power off and start over in this case.
■ Channel selection
Several types of channel selections are available. Methods
may differ according to your system set up.
NON-ZONE TYPE:
To select the desired operating channel:
•Push[CHUp]or[CHDown].
•Pushoneof[MR-CH1]to[MR-CH4].
ZONE TYPE:
To select the desired zone:
•Push[Zone],thenpush[CHUp]or[CHDown].
•Push[ZoneUp]or[ZoneDown].
D Voting operation
The transceiver automatically starts scanning when a zone,
specified for the voting operation, is selected.
The voting scan detects the S-meter of the repeater and au-
tomatically selects the strongest station.
AUTOMATIC SCAN TYPE:
Channelsettingisnotnecessaryforthistype.Whenturn-
ing power ON, the transceiver automatically starts scanning.
Scanning stops when receiving a call.
KEY
NUMBER
0
5
4
9
3
8
2
7
1
6

Icom IC-F6062 Specifications

General

Brand	Icom
Model	IC-F6062
Category	Transceiver
Language	English