Need help?Do you have a question about the Icom IC-F6023 and is the answer not in the manual?
General| Frequency Range | 136-174 MHz |
|---|---|
| IP Rating | IP54 |
| Modulation | 16K0F3E / 11K0F3E |
| Channel Spacing | 12.5 / 25 kHz |
| Battery Life | N/A (Mobile unit, typically powered by vehicle) |
Critical warnings to prevent transceiver damage and ensure safe operation.
Details general operating parameters like frequency range and power requirements.
Covers output power, modulation, and frequency error for transmission.
Covers sensitivity, selectivity, and audio performance for reception.
Identifies components on the front unit's circuit board (top view).
Identifies components on the top of the main-A unit's circuit board.
Identifies components on the bottom of the main-A unit's circuit board.
Provides sequential steps and visual guides for taking the unit apart.
Details how to install optional accessories and modules like UT-108R, UT-109R.
Explains the RF, IF, and demodulator stages of the receiver.
Details the MIC amplifier, TX AF, and TX amplifier stages.
Covers frequency generation and power distribution block diagrams.
Lists and describes pin functions for CPU (Front Unit) and Expander (Main Unit).
Lists necessary equipment and software for performing adjustments.
Details procedures for frequency calibration and receiver sensitivity tuning.
Covers adjustments for output power, modulation balance, and deviation.
Comprehensive list of parts for the main-A unit.
Comprehensive list of parts for the front unit.
Lists chassis, front unit, and accessories with part numbers and quantities.
Visual guides showing component placement on the main-A and front unit boards.
Illustrates wiring between front unit, main unit, and external connectors.
High-level functional overview of the main-A and front unit signal paths.
Details voltage lines and signals within the front unit.
Details voltage lines and signals within the main-A unit.
To Next Page
