Icom IC-M410BB - Page 16

3
2
PANEL DESCRIPTION
■ Function Display (INFO screen)
L When you switch the main screen between the INFO, the Plotter, and the MOB screens,
push
.*
1 2 34 5 6
7
8 9  .

D
F
G





1BUSY/TRANSMIT
• is displayed when receiving a
signal or the squelch is open.
•
is displayed while transmitting.
2ANCHOR WATCH INDICATOR
(For only the IC-M510BB)
Displayed when the Anchor Watch
function is activated. (p. 65)
3POWER
• “25W” is displayed when high power is
selected.
• “1W” is displayed when low power is
selected.
4RX HAILER (p. 69)
Displayed while in the RX Hailer mode.
AUTO FOGHORN (p. 71)
is displayed when the Auto Foghorn
function is activated.
L takes precedence over on the
screen.
5CHANNEL GROUP (p. 9)
Displays the selected channel group.
L Theselectablechannelsdi󰀨er,
depending on the version or presetting.
6CALL CHANNEL (p. 12)
Displayed when the Call channel is
selected
7DUPLEX
Displayed when a Duplex channel is
selected.
8FAVORITE CHANNEL (p. 15)
Displayed when a Favorite channel is
selected.
9MESSAGE (p.41)
• Displayed when there are unread DSC
messages
• Blinks when a DSC message is received.
  GPS INDICATOR
• Displayed when the transceiver receives
valid position data.
• Blinks when invalid GPS data is being
received.
.  CH AUTO SWITCH (p.44)
Displayed when
“CH AUTO SWITCH” is
set to anything other than “Accept.”
  RT (Radio Telephone) INDICATOR
Displayed while in the Radio Telephone
mode.
L The transceiver returns to the Standby
mode if no operation occurs during the
preset period of time.
D  VOICE RECORD (p. 67)
(For only the IC-M510BB)
• is displayed while recording the audio.
•
is displayed while playing back the
recorded audio.
LOW BATTERY INDICATOR
is displayed when the battery voltage
is low.
F  CH NUMBER READOUT
Displays the selected channel number
G  CH NAME FIELD (p. 12)
The channel name is displayed.
* For only the IC-M510BB.
FELLECS-TECH | inbox@fellecs-tech.com | www.fellecs-tech.com