Why can't I select the desired set mode item on my Icom IC-R20?
If you cannot select your desired set mode item on the Icom Receiver, the “EXPAND” item may be set to OFF. Turn the “EXPAND” item ON.
What to do if no sound comes from the Icom Receiver speaker?
If you are not getting any sound from the Icom Receiver's speaker, first, ensure the volume isn't too low by rotating the [R-DIAL] or pushing [Y] to adjust it. Also, check if the squelch level is set too high by pushing [SQL] and rotating [R-DIAL] to adjust the squelch level. Finally, if using tone squelch, verify that the correct tone is selected and turn the function OFF if needed.
How to fix an Icom Receiver that won't power on?
If your Icom Receiver isn't powering on, the batteries may be exhausted. Try replacing them or charging the battery pack. Also, ensure that the battery polarity is correct when inserting them.
General| Mode | AM, FM, WFM, SSB, CW |
|---|---|
| Antenna Connector | BNC |
| Memory Channels | 1250 |
| Selectivity | AM/FM |
| Output Power | 150mW at 8 Ohms |
| Battery Life | Approx. 8 hours with BP-206 (at 50mW audio output) |
To Next Page
