Icom IC-T22E - Page 27

© Full/programmed scan
® Push [VFO] to select VFO mode.
@ Set [SQL] to the point where noise is muted.
@ Start the desired scan.
‘» For full scan: Push [A/SCAN] or [V/SCAN] for 1 sec.
“* For programmed scan: Push [FUNC] + [A/SCAN] or
[V/SCAN] to start programmed scan.
«“P1,” “P2" or “P3" appears to indicate which pair of scan
edges is being scanned.
@ Push [©], [®] or [@] to select the desired scan range or
push [©] to select full scan.
© To stop the scan, push [A/SCAN] or [V/SCAN].
GY NOTE: For programmed scan, scan edges must be pro-
Z grammed in advance. Program scan edges in the same
Z manner as regular memory channels (p. 17)
Z If the same frequencies are programmed into a pair of
Z scan edges, programmed scan edge appears, such as
(7, “P 1,” but programmed scan does not proceed.
v CONVENIENT:
The frequency skip function is utilised to skip undesired sig-
nals which pause a scan (p. 24).
ADVANCED FUNCTIONS 4
© Memory (skip) scan
@ Push [MR] to select memory mode.
@ Set the [SQL] to the point where noise is muted.
@ Start the desired scan,
‘» For memory scan: Push [A/SCAN] or [V/SCAN] for 1
sec.
‘> For memory skip scan: Push [FUNC] + [A/SCAN] or
[V/SCAN].
@ To stop the scan, push [A/SCAN] or [V/SCAN].
© Setting a skip channel
Memory channels can be set to be skipped for memory skip
scan. This is useful to speedup the memory skip scan inter-
val.
@ Select the memory channel to be programmed as a skip
channel:
‘» Push [MR] to select memory mode.
‘» Rotate [DIAL] (or use the keypad) to select a memory
channel.
@ Push [FUNC] + [@SKIP] to set the
memory channel as a skip chan-
nel.
* “SKIP” appears.
@ Repeat step @ to cancel a skip
channel.
* “SKIP” disappears.
B|