Icom IC-T22E - Page 28

4 ADVANCED FUNCTIONS
© Frequency skip function
When you want to skip undesired signals that inconveniently
pause full or programmed scan, the frequency skip function
is available.
Push [FUNC] + [(mA)MW] while scan is paused on an unde-
sired signal. The frequency is programmed into the highest
non-programmed memory channel as a skip frequency. Skip
frequencies are subsequently “skipped” during scanning.
Z NOTE: When the frequency skip function is turned OFF,
Z pushing [FUNC] + [(mR)MW] while scan is paused on a
Z signal overwrites the frequency as a regular memory
(, channel.
SSS
© Frequency skip function ON/OFF = SET MODE
@® Push [FUNC] + [®SET] to enter
set mode.
® Push [V] or [A] one or more times
until “PS” appears.
* “SKIP” also appears.
@ Rotate [DIAL] to turn programmed
skip scan ON or OFF.
*When selecting “ON,” programmed
skip scan is activated for full or pro-
grammed scan and “SKIP” appears and flashes during scanning.
@ Push [(vFo)CLR] to set the condition and to exit set mode.
© Scan resume condition vswo SET MODE
The resume condition can be selected as a pause or timer
scan. The resume condition is used for scan and priority
watch (p. 24).
@® Push [FUNC] + [®SET] to enter set mode.
@ Push [V] or [A] one or more times until “SC” appears.
@ Rotate [DIAL] to select the desired
scan resume condition. T ae
mt SE
*"T-15": scan pauses for 15 sec. ona ‘
received signal.
*“T—10": scan pauses for 10 sec. ona
received signal.
*“T-05": scan pauses for 5 sec. ona
received signal.
*“P-02": scan pauses on a received
signal until it disappears.
@ Push [(vFo)CLR] to set the condition and to exit set mode.