Icom IC-T22E - Page 31

> Programming
@ Push [FUNC] + [®CODE] to select
the code channel setting display.
@ Rotate [DIAL] to select the desired
code channel, CO—CS5.
* Code channel CP cannot be used for
programming.
@ Push the numeral keys to input the
desired 3-digit code.
* Digit keys are automatically stored
once the 3rd digit has been entered.
* When a digit key is mistakenly input,
push [(vFo)CLR] and enter the de-
sired code from the beginning.
@ Push [FUNC] + [@SKIP] to set the
channel for “receive inhibit” or “re-
ceive accept.”
¢When “receive inhibit” is set, “SKIP”
appears.
BE ce
ou
ELIE
MIME
* Code channel CO cannot be set as “receive inhibit.”
* See below for “receive accept” and “receive inhibit" details.
© Push [(vFo)CLR] to exit the setting display.
* Receive accept/receive inhibit
‘= “Receive accept” ("“SKIP” indicator does not appear) ac-
cepts pager calls when the transceiver receives a signal
with a code the same as that in the code channel.
‘» “Receive inhibit” (“SKIP” indicator appears) rejects calls
ADVANCED FUNCTIONS 4
even when the transceiver receives a code the same as
that in the code channel. Transmit codes should therefore
be programmed for “receive inhibit,” otherwise the trans-
ceiver will not reject unnecessary calls.
Y During code squelch operation, the power saver duty cycle
% becomes 1 : 1 if the power saver is activated.
3