Icom IC-T22E - Page 32

4 ADVANCED FUNCTIONS
@ Pager operation
© Calling a specific station
@ Program the needed code channel in advance.
® Set the operating frequency.
® Push [FUNC] + [@PGR/CSQL] once or twice to turn the
pager function ON.
«“P” appears in place of the 100 MHz
digit.
*An optional* tone squelch can be
used in conjunction with the pager
function.
@ Select the desired transmit code channel:
‘» Push [FUNC] + [OCODE].
‘» Rotate [DIAL] to select the channel.
© Push [PTT] to transmit the pager code.
© Wait for an answer back.
* When the transceiver receives an answer back code, the function
display shows the other members’ ID or group code.
@ After confirming a connection push [(vFo)CLR] to display
the operating frequency.
*DO NOT push any digit keys while code channels CO to C5 are
displayed, or code channel contents are changed.
® Push [FUNC] + [®PGR/CSQL] once to select the code
squelch or twice to select the non-selective calling system.
© Waiting for a call from a specific station
@ Set the operating frequency.
@® Push [FUNC] + [®@PGR/CSQL] once or twice to turn the
pager function ON.
*“P” appears in place of the 100 MHz digit.
* An optional* tone squelch can be used in conjunction with the
pager function.
® Wait for a call.
* When receiving a call, the callers’ ID or group code appears as
shown at right.
*DO NOT push any digit keys while code channels CO to C5 are
displayed, or code channel contents are changed.
@ Push [PTT] to send an answer back call and display the op-
erating frequency.
® Push [FUNC] + [®@PGR/CSQL] once to select the code
squelch or twice to select the non-selective calling system.