Icom IC-T22E - Page 35

CC
CC
Orr
© Transmitting a message
© Set the transceiver for pager or code squelch operation.
+
Remember
that
pager
code
programming,
etc.
for
each
trans-
ceiver in a group is necessary.
For memory transmission:
@
Push
[FUNC]
+
[MSG]
to
turn
the
message
function
ON.
+ “(455)” appears.
@ Push and hold [PTT].
* The pager or code squelch code is transmitted.
@ While continuing to push [PTT], push the corresponding
digit key for the transmit message memory.
+0" to “5" correspond to transmit message memories “TO” to “T5.”
For manual transmission:
® Push [FUNC] + [MSG] to turn the message function OFF.
“(#55)”
disappears
(when
the
message
function
is
turned
ON,
memory contents are automatically transmitted).
® Push and hold [PTT].
* The pager or code squelch code is transmitted.
@
While
continuing
to
push
[PTT],
push
[A#],
then
push
the
corresponding digit keys for the desired message.
* Refer to the table on page 39 for details.
® When the desired message has been input, push [A#] to
signal the end of the transmission.
[EXAMPLE]:
eX ofofoqoloy
ADVANCED FUNCTIONS 4
@ Subaudible tone operation
Some
versions
of
this
transceiver
have
a
built-in
subaudible
tone
encoder
as
standard.
When
an
optional"
UT-94
is
in-
Stalled,
the
tone
decoder
function
becomes
additionally
avail-
able
and
allows
you
to
operate
the
tone
squelch,
tone
scan
and
pocket
beep
functions.
Refer
to
p.
32
for
unit
installation.
© Tone squelch operation
The
tone
squelch
opens
only
when
receiving
a
signal
con-
taining
a
matching
subaudible
tone.
You
can
silently
wait
for
calls
from
group
members
using
the
same
tone.
© Set the operating frequency.
@ Set the desired subaudible tone in set mode.
*
See
p.
39
for
a
list
of
tones
available
and
p.
15
for
programming.
® Push [FUNC] + [©T/TSQL] until “TSQL” appears.
* The code squelch can be used with the tone squelch (p. 28).
@When
the
received
signal
includes
a
matching
tone,
squelch opens and the signal can be heard.
*
When
the
received
signal's
tone
does
not
match,
squelch
does
not open, however, the S-indicator shows signal strength.
* To open the squelch manually, push and hold [MONI].
© Operate the transceiver in the normal way.
© To cancel the tone squelch, push [FUNC] + [OT/TSQL].
ia SAS rte es cn en ate a
v CONVENIENT
Store
subaudible
tone
frequencies
and
tone
squelch
ON/OFF
settings in memories (call) for easy recall.
8|