Icom IC-T22E - Optional Unit Installation

@ Installing the optional UT-94
TONE SQUELCH UNIT
An optional UT-94 TONE SQUELCH UNIT is available for this
transceiver. The UT-94 provides tone scan, tone squelch and
pocket beep functions.
@ Turn power OFF, then remove the battery pack and/or DC
power cable.
@ Unscrew the 6 screws as shown below.
ADVANCED FUNCTIONS 4
® Carefully separate the front and rear panels as shown
below.
@ Plug in the UT-94 as shown below.
* Pull the brown part of
the connector.
* Insert the ribbon cable
of the UT-94 into the
connector (silver end
facing upwards).
* Replace the brown part
of the connector.
* Gently tug on the UT-94
to confirm that it has
been correctly installed.
© Reassemble the front and rear panels; then, replace the 6
screws removed in step @.
B|