Icom IC-W2E - Page 23

@ Offset
frequency
The offset frequency can be separately set on the UHF and
VHF bands.
use SET MODE
The display shows
the offset frequency
for 600 kHz (0.6
MHz) in the VHF
band.
68 448.88
REPEATER OPERATION 6
@ Subaudible tone ..... sev move
frequency
The subaudible tone frequency can be set separately on the
VHF and UHF bands.
The display shows
the 88.5 Hz subau-
dible tone trequen-
cy in the VHF band.
[Main]
885 4W4E8o
1) Push [V MAIN] or [U MAIN] to select the desired band.
2) Push [@ V/M] to enter VFO mode. (‘‘M"' disappears.)
3) While pushing [F], push [(8) SET] to enter SET mode.
* Refer to p. 22 for SET mode details.
4) Push [A/SCAN] or [V/SCAN] until “OW” appears as
shown above.
5) Rotate the main dial to select the desired offset frequency.
* For quick selection, rotate the main dial while pushing [F].
6) Push [&) CLR] to exit SET mode.
1) Push [V MAIN] or [U MAIN] to select the desired band.
2) Push [@) V/M] to enter VFO mode. (‘‘M"’ disappears.)
3) While pushing [F], push [@) SET] to enter SET mode.
* Refer to p. 22 for SET mode details,
4) Push [A/SCAN] or [V/SCAN] until “TO'’ appears as
shown above.
5) Rotate the main dial to select the desired subaudible tone
frequency.
6) Push [® CLR] to exit SET mode.