Need help?Do you have a question about the Icom IC-W2E and is the answer not in the manual?
General| Modulation | FM |
|---|---|
| RF Power Output (VHF) | 5W |
| RF Power Output (UHF) | 5W |
| Channels | 200 |
| Frequency Range TX | 144-146 MHz, 430-440 MHz |
Initial checks, battery charging, and powering on the transceiver.
Connecting antenna, resetting transceiver, and setting audio levels.
Methods for setting frequencies, receiving signals, and transmitting.
Description of controls and connectors on the top and side panels.
Detailed explanation of front panel keys and their operational functions.
Explanation of symbols and indicators shown on the transceiver's display.
Different ways to charge the battery pack using supplied or optional chargers.
Important charging notes, battery life information, and usage recommendations.
Instructions for attaching the handstrap and belt clip to the transceiver.
How to remove the battery pack and install batteries into the battery case.
Methods to set frequencies using main dial, keys, and numeral input.
Using numeral keys for precise frequency input.
Adjusting frequency tuning increments and dial select steps.
Activating PTT lock and selecting low output power levels.
Basic principles and procedures for operating via a repeater.
Details on tone types and setting offset/tone frequencies.
Overview of different operating modes like VFO, Memory, Clock, etc.
Visual guide showing transitions between different operating modes.
Procedures for calling up and transferring call channel frequencies.
Steps to program operating frequency and duplex for call channels.
How to select a memory channel from the available ones.
Steps to program frequencies and settings into memory channels.
Copying memory contents and hiding or unhiding channels.
Different scan modes and how scanning resumes after a signal.
Step-by-step guide for performing various scan operations.
How to program scan edges for programmed scanning.
Setting up and managing the frequency skip function.
Configuring skip channels and scan resume conditions.
Different priority watch modes and how to operate them.
How to program and transmit DTMF codes.
Controlling beep tones and adjusting display lighting.
How to activate and configure the power saver for battery conservation.
Setting auto-off periods and accessing clock mode.
How to set the clock time and indications.
Configuring and operating the power-on timer.
Configuring and operating the power-off timer.
Introduction to pager and code squelch functions.
Steps for programming codes for pager and squelch functions.
Procedures for calling specific stations and waiting for calls.
How to activate and use the code squelch feature.
Steps for installing the optional UT-63 unit.
How to use pocket beep and tone squelch features.
To Next Page
