Icom IC-W2E - Skip Channel and Resume Condition Settings

10 SCAN OPERATION
@ Skip channel setting
Memory channels can be specified to be skipped for memory
skip scan. These skip channels are also skipped during pri-
ority watch (memory scan watch) and the frequencies of the
channels are skipped during full or programmed scan.
1) Select the memory channel to be programmed as the skip
channel:
- Push [@ V/M] to select MEMORY mode. (‘'M’’ appears.)
- Rotate the main dial to select the desired memory channel.
2) Push [@) SKIP] to set the memory channel to the skip
channel.
* “SKIP” appears.
3) Repeat the above steps to delete the memory skip func-
tion from the memory channel.
* “SKIP” disappears.
@ Scan resume
condition
The resume condition can be selected as a pause or timer
scan. The resume condition is not only used for scan but
also for priority watch.
uswa SET MODE
Timer scan: Pause scan:
Scan pauses for 5 sec. Scan pauses until a signal
when receiving a signal. disappears,
1) Enter SET mode:
- Push [V MAIN] or [U MAIN] to select the desired band.
- Push [@) V/M] to select VFO mode. (‘‘M’’ disappears.)
- While pushing [F], push [(8) SET] to enter SET mode.
2) Select the scan resume display:
- Push [A/SCAN] or [V/SCAN] several times until “SC’’ appears
as shown above.
3) Rotate the main dial to select ‘‘timer scan”’ or ‘pause
scan.
4) Push [& CLR] to exit SET mode.