Icom IC-W2E - Frequency Skip Function Management

@
Frequency
skip
function
¢
Programming
a
skip
frequency
Frequencies
can
be
skipped
when
the
programmed
scan
or
the
full
scan
is
in
the
pause
condition.
Memory
channels
30~11
program
skip
frequencies
in
sequence.
When scan pauses. Appears at the moment of programming.
SCAN OPERATION 10
¢ Frequency skip function
ON/OFF
usa SET MODE
oo
oFF YFG
oP f
Skip function OFF
4378S
Skip function ON
1) Turn ON the frequency skip function.
* After CPU resetting, the function is automatically turned ON.
* To turn the function ON or OFF, see ‘Frequency skip function
ON/OFF" at right.
2) Start full scan or programmed scan.
* See p. 28 ‘Scan operation’ for details.
3) Program the received frequency as the skip frequency
when scan is paused:
- While pushing [F], push [@ V/M] for 1 sec.
1) Enter SET mode:
~ Push [V MAIN] or [U MAIN] to select the desired band.
- Push [@ V/M] to select VFO mode. (''M’’ disappears.)
- While pushing [F], push [@) SET] to enter SET mode.
2) Select the frequency skip display:
- Push [A/SCAN] or [V/SCAN] several times until ‘SKIP PS”
appears as shown above.
3)
Rotate
the
main
dial
to
turn
the
function
ON
or
OFF.
4) Push [® CLR] to exit SET mode.