Icom IC-W2E - Programmed Scan Edge Setup

10 SCAN OPERATION
@ Programmed scan edges
Programmed scan edges can be programmed in the same
way as memory writing. Memory channels “PA” and ‘‘PB’’
are available for programmed scan edge programming.
1) Push [V MAIN] or [U MAIN] to select the desired band.
2)
Select
the
scan
edge
memory
channel
“PA”
or
“PB”:
-
Push
[@
V/M]
to
select
MEMORY
mode.
(‘‘M’’
appears).
-
Rotate
the
main
dial
to
select
the
memory
channel
“PA”
or
“PB.”
3) Set the desired edge frequency in VFO mode:
- Push [@ V/M] to select VFO mode.
- Set the desired frequency to be programmed into the memory
channel.
4) While pushing [F], push and hold [@) MW] until the tran-
sceiver emits 3 beeps.
5) To program a frequency for the other scan edge memory
channel “PB” or “PA," repeat steps 2~4.
* If the same frequencies are programmed into “‘PA"’ and “PB,”
programmed scan will not function.
V MAIN vine awe
VON
Select VFO mode. Select memory channel *'PA.”’
then
5.80 4F78C
Set 145.80 MHz in VFO mode.
Select memory channel 'PB.""
—
[EXAMPLE]:
Program
145.50
MHz
and
145.80
MHz
for
the
scan
edges.
[rain]
5.80 478d
Hold for 1 sec.
‘el vad Fan,
=r @ =
558 4F71GE
Basin]
559 4F71aC
PR 3G
Select 145.50 MHz in VFO mode. Program
Hold for 1 sec.
vee neve
or @) =>
am
45.88 4Z71GC
Beep
ae
py 3
Program is completed.
29