To Next PageTo Next PageHow to unlock frequency setting on Icom IC-V85?
If you can't set the frequency on your Icom Transceiver, it might be because the key lock function is activated. To cancel it, push [FUNC] then push and hold [ ](?ENT) for 1 second. Another possibility is that Memory mode or call channel is selected. Push [CLR] to set VFO mode.
How to fix Icom IC-V85 when no power comes on?
If your Icom Transceiver isn't powering on, it could be due to several reasons. First, the batteries might be exhausted, so try replacing them or charging the battery pack. Another possibility is reversed battery polarity; double-check that the battery polarity is correct. Lastly, the battery’s temperature protection circuit might be activated. Allow the BP-227 to cool down.
What to do if no sound comes from the Icom Transceiver speaker?
If no sound is coming from the speaker of your Icom Transceiver, the volume level might be too low. Rotate the [VOL] knob to a suitable level. Alternatively, a different tone may be selected with tone/DTCS squelch. Check the tone using tone/DTCS scan.
What causes erroneous frequency display on Icom Transceiver?
If the displayed frequency on your Icom Transceiver is erroneous, it could be due to a CPU malfunction. Try resetting the transceiver. Alternatively, external factors might have caused a fault; remove and re-attach the battery pack or battery case.
General| Frequency Range | 136-174 MHz |
|---|---|
| Mode | FM |
| Receiver System | Double-conversion superheterodyne |
| Number of Channels | 200 |
| Waterproof | IP54 |
| Audio Output Power | 700 mW |
| Battery Life | 8 hours (approx.) |
| RF Output Power | 5 W (high), 1 W (low) |
| Selectivity | 12 kHz |
