Icom IC-V85 - 13 CLONING; TRANSCEIVER-TO-TRANSCEIVER CLONING PROCEDURE

59
CLONING
13
q Connect the OPC-474 CLONING CABLE to the [SP] jack of
the master and sub-transceivers.
• The master transceiver is used to send data to the sub-trans-
ceiver.
w While pushing [FUNC] and [
YY
], turn power ON to enter
cloning mode (master transceiver only— power ON for
sub-transceiver).
• “CLONE” appears and the
transceivers enter the clone
standby condition.
DUP
SCAN
PRIO
SET
H/M/L
OPT
SKIP
BANK
TONE
T.SCAN
P.BEEP
A
B
D
C
CALL
ENT
MR
CLRFUNC
PWR
9
8
7
4
1
2
3
56
0
A
FUNC
PWR
Master transceiver
Sub transceiver
Cloning allows you to quickly and easily transfer the pro-
grammed contents from one transceiver to another trans-
ceiver.
■ Transceiver-to-transceiver cloning
AT
POWER ON