38
8
SCAN OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
■ Priority watch
Priority watch checks for signals on “priority channels” while
operating on a VFO frequency.
D Memory or call channel watch
While operating on a VFO frequency, memory or call channel
watch monitors for signals in the selected memory or call
channel every 5 sec.
qSelect the desired memory channel or the call channel.
wPush [CLR] to select VFO mode.
ePush [FUNC], then push [
PRIO
](7) to start watching.
• VFO is displayed, then the decimal point “.”, on the frequency
readout blinks.
• The priority channel is monitored every 5 sec.
• When the signal is detected on the priority channel, the watching
is suspended according to the setting of the scan resume condi-
tion.
rPush [CLR] to stop watching.
D Memory scan watch
While operating on a VFO frequency, memory scan watch
monitors for signals in each memory channel in sequence,
every 5 sec.
qPush [MR] to select memory mode, if necessary.
•“X” appears.
wPush [FUNC], then push [
SCAN
](5) to start the memory
scan.
ePush [FUNC], then push [
PRIO
](7) to start the watching.
• VFO is displayed, then the decimal point “.”, on the frequency
readout blinks.
• When the signal is detected on the priority channel, the watching
is suspended according to the setting of the scan resume condi-
tion.
rPush [CLR] to stop the watching.
To Next Page
Loading...
