Need help?Do you have a question about the Icom Ic-V88 and is the answer not in the manual?
General| Type | Handheld Transceiver |
|---|---|
| Frequency Range | 136-174 MHz |
| Modulation | FM |
| Number of Channels | 128 |
| Channel Spacing | 12.5/25 kHz |
| IP Rating | IP54 |
| Voltage | 7.2V |
| Antenna Impedance | 50 Ω |
| Battery | Li-Ion |
| Operating Voltage | 7.2V |
| Battery Life | Approx. 10 hours |
Instructions for connecting the antenna to the transceiver's antenna connector.
Instructions on connecting the supplied or optional antenna to the antenna connector.
Instructions for attaching or detaching the battery pack to the transceiver.
Instructions for attaching and detaching the belt clip to the transceiver.
Instructions for attaching and detaching the jack cover to protect the microphone jack.
Explains assigning functions to programmable keys like [PO], [P1], [P2], [P3], [TOP], [UP], [DOWN].
How to use CH Up/Down keys to select options, settings, or zones.
How to select a desired zone by pushing [CH Up] or [CH Down].
Instructions to start, stop, and select scan groups.
How to add or delete the current channel from a scan group.
How to select Priority A or B channels.
How to assign the operating channel to Priority A or B.
How to directly select memory channels 1, 2, 3, or 4.
How to cancel CTCSS/DTCS mute and enter audible mode.
How to lock and unlock all programmable keys.
How to temporarily select the transmit output power.
How to enter the Continuous Tone Selection mode.
How to turn the Talk Around function ON or OFF.
How to toggle the channel passband width between wide and narrow.
How to enter DTMF selection mode and transmit codes.
How to transmit the last-transmitted DTMF code.
How to turn the Surveillance function ON or OFF.
How to sound a siren or use it as a security alarm.
How to turn the Voice Scrambler function ON or OFF.
How to turn the Compander function ON or OFF to reduce noise.
How to enter and exit the User Set mode.
How to turn the Channel Announce function ON or OFF.
How to turn Shift mode ON/OFF to access secondary key functions.
Explains the MDC 1200 system, PTT ID, and aliasing features.
Details how to receive a PTT ID and what information is displayed.
Details how to transmit a PTT ID and how it is displayed at the receiving end.
Enables customization of transceiver settings to suit preferences.
Instructions on how to enter and exit the User Set mode.
Configuration options for LCD and key backlight behavior.
Control for enabling or disabling beep sounds.
How to adjust the beep audio level using the VOL knob.
How to adjust the ringer audio level using the VOL knob.
How to set the squelch level to suppress background noise.
How to set the minimum audio output level.
How to adjust microphone sensitivity for voice input.
Enable or disable the battery voltage display on startup.
Control for enabling or disabling DTMF tones sound.
Allows changing settings like frequencies, tones, and channel names without a PC.
Step-by-step instructions to enter the programming mode.
Instructions to exit the programming mode and return to normal operation.
Guides on selecting a specific channel to program.
Instructions to edit the RX and TX frequencies for a channel.
Instructions to select RX and TX CTCSS tones or DTCS codes.
How to select the CTCSS tone frequency for a channel.
How to select the DTCS code for a channel.
Instructions to assign or change the name of a channel.
Covers deactivating channels, clearing memory, and inhibiting transmission.
How to temporarily deactivate a channel and then reactivate it.
Instructions to clear the stored RX frequency memory for a channel.
How to toggle the channel passband width between Wide and Narrow.
How to inhibit or allow transmission for a channel.
To Next Page
