Icom IC-V80 User Manual

This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
INSTRUCTION MANUAL
iV80
iV80 E
VHF TRANSCEIVER
WARNING: MODIFICATION OF THIS DEVICE TO RECEIVE
C E L L U L A R R A D I OT E L E P H O N E SE RVI C E S I G N A L S I S
PROHIBITED UNDER FCC RULES AND FEDERAL LAW.

Icom IC-V80 Specifications

General

Frequency Range	136-174 MHz
Mode	FM
Waterproof	IP54
Dimensions	58 x 112 x 30 mm
Operating Voltage	7.2 V DC
Channels	207 (200 memory channels, 6 scan edges, and 1 call channel)

Summary

PRECAUTIONS

FCC INFORMATION

PANEL DESCRIPTION

BATTERY CHARGING

Ni-MH Battery Precautions

Covers critical safety warnings for handling, charging, and using the Ni-MH battery pack.

Li-Ion Battery Precautions

Details hazards and safety measures associated with Li-Ion battery misuse.

BASIC OPERATION

Receiving

Guides on how to receive signals, adjust volume, frequency, and squelch.

Transmitting

Explains the process for transmitting signals, including power settings and microphone usage.

REPEATER AND DUPLEX OPERATION

Repeater Operation

Explains how to set frequencies and tones for repeater communication.

REPEATER OPERATION

Duplex Operation

Details how to set frequency offset and duplex direction for repeater operation.

MEMORY/CALL OPERATION

Channel Programming

Step-by-step guide to programming frequencies and other data into memory channels.

SCAN OPERATION

TONE SQUELCH AND POCKET BEEP

Tone Squelch and Pocket Beep Functionality

Explains tone/DTCS squelch for selective calling and pocket beep for pager-like notifications.

DTMF MEMORY

Programming a DTMF Code Sequence

Step-by-step guide to programming DTMF codes into memory channels.

SET MODES

Set Mode Overview

Explains how to access and change transceiver settings using the Set mode.

Key Set Mode Items

Lists and describes items configurable in Set mode, including tone, DTCS, and polarity.

Initial Set Mode Items Overview

CLONING

Cloning Operation

RESETTING

Resetting Procedures

TROUBLE SHOOTING

Troubleshooting Common Issues

Guides users through common problems and their potential solutions.

SPECIFICATIONS

General Specifications

Transmitter Specifications

Receiver Specifications

CE