49
RESETTING
12
■ Resetting
The LCD may occasionally display erroneous infor-
mation (e.g. when first applying power). This may be
caused externally by static electricity or by other factors.
If this problem occurs, turn power OFF. After waiting a
few seconds, turn power ON again. If the problem per-
sists, perform either or both of the procedures below.
D Partial reset
If you want to reset the operating conditions (VFO fre-
quency, VFO settings, and Set modes contents) with-
out clearing the memory contents, use the partial reset.
q Push and hold [ ] for 1 sec. to turn the power OFF.
w While pushing and holding [VFO/MR/CALL], push and
hold [ ] for 1 sec. to turn the power ON.
NOTE: No message appears on the display after the par-
tial reset is done.
D All reset
The all reset clears all programming and returns all
settings to their factory defaults.
q Push and hold [ ] for 1 sec. to turn the power OFF.
w While pushing and holding [MONI] and [VFO/MR/CALL],
push and hold [ ] for 1 sec. to turn the power ON.
• “CLEAR” appears when resetting the CPU.
CAUTION: The all reset returns all programmed contents
to their default settings.
To Next Page
Loading...
