23
■ Lockout function
The lockout function helps prevent interference to other sta-
tions by inhibiting transmitting when the channel is busy.
The function can be set in the Initial Set mode.
q While pushing and holding [] and [], turn the power
ON to enter the Initial Set mode.
w Push [] or [] to select the lockout item. (RLO)
e Rotate [VOL] to select the lockout function option be-
tween OFF, repeater lockout, and busy lockout.
• “RLO.OF” : Allows transmitting, even if signals are received.
• “RLO.RP” : The repeater lockout function inhibits transmitting
when the channel is busy, except while receiving a
signal that includes a matched subaudible tone.
• “RLO.bU” : The busy lockout function inhibits transmitting while
receiving a signal.
r Push [# ENT] to exit the Initial Set mode.
■ Auto repeater function
The auto repeater function sets the standard repeater set-
tings (duplex ON/OFF, duplex direction, tone encoder ON/OFF)
when the operating frequency falls within or outside of the
general repeater output frequency range. The offset and
repeater tone frequencies are not changed by the auto re-
peater function. Reset these frequencies, if necessary.
The function can be set in the Initial Set mode.
q While pushing and holding [] and [], turn the power
ON to enter the Initial Set mode.
w Push [] or [] to select the auto repeater item. (RPt)
e Rotate [VOL] to select a desired option.
• “Rpt.OF” : Turns the function OFF.
• “Rpt.R1” :
The auto repeater function is activated for duplex only.
• “Rpt.R2” : The auto repeater function is activated for duplex and
tone encoder.
r Push [# ENT] to exit the Initial Set mode.
• Frequency range and offset direction
5
REPEATER OPERATION
U.S.A. version only
Frequency range Duplex direction
145.200 to 145.495 MHz
146.610 to 146.995 MHz
“–” appears.
147.000 to 147.395 MHz
“+” appears.
To Next Page
Loading...
Need help?
General
