48
10
11
11
CLONING
■ Cloning operation
Cloning allows you to quickly and easily transfer the
programmed contents from one transceiver to another.
D Transceiver-to-transceiver cloning
q Turn the transceiver’s power OFF, and then connect an
optional OPC-474 cloning cable to the [SP] jacks of the
master transceiver and the sub transceiver.
• The master transceiver is used to send data to the sub trans-
ceiver.
w While pushing [FUNC](M) and [], turn the master trans-
ceiver ON to enter the cloning mode.
• “CLONE” appears
e Turn the sub transceiver ON.
r Push [PTT] on the master transceiver.
• “CL Out” appears on the master transceiver’s display, and the
signal indicator shows the data is being transferred to the sub
transceiver.
• “CL In” appears on the sub transceiver’s display, and the signal
indicator shows the data is being received from the master
transceiver.
t
When cloning is finished, turn both the transceivers OFF.
Then turn them ON again to exit the cloning mode.
NOTE: DO NOT push [PTT] on the sub transceiver dur-
ing cloning. This will cause a cloning error.
D Cloning using a PC
The CS-V80 cloning software is also used to clone/edit con-
tents with a PC (for Microsoft
®
Windows
®
2000/XP or Win-
dows Vista
®
) using ICF format files.
Refer to the INSTRUCTIONS and the Help file that come
with the CS-V80, for details.