Icom IC-V85 - REPEATER OPERATION; AUTO REPEATER FUNCTION (USA ONLY)

25
5
REPEATER OPERATION
The USA version automatically activates the repeater settings
(duplex ON/OFF, duplex direction, tone encoder ON/OFF)
when the operating frequency falls within or outside of the
general repeater output frequency range. The offset and re-
peater tone frequencies are not changed by the auto repeater
function. Reset these frequencies, if necessary.
q While pushing and holding [
YY
] and [
ZZ
], turn the power ON
to enter
INITIAL SET MODE .
w Push [
YY
] or [
ZZ
] several times until “RPt” appears.
e Rotate [VOL] to select the desired condition.
• “OF”— the auto repeater function is turned OFF;
• “R1”— the auto repeater function activates duplex only;
• “R2”— the auto repeater function activates duplex and tone.
r Push [✱ ENT ] (or [CLR]) to exit INITIAL SET MODE .
• Frequency range and offset direction
Frequency range Duplex direction
145.200–145.495 MHz
“–” appears
146.610–146.995 MHz
147.000–147.395 MHz “+” appears
■ Auto repeater function (USA version only)
USING
INITIAL SET MODE